IBM INFO PRINT 3000 - Manual (Page 229)

11. When the developer stops running, close the developer drain by pushing the
Developer Drain Lever B downward and then pushing it in.
12. Once the developer mix has finished draining, ensure that no developer mix
remains in the drain hose. Do this by shaking the hose vigorously while you
hold the hose as vertical as possible.
13.
Remove the developer drain hose from the bottle. Put the cap on the
developer drain hose, and return the hose to its recessed storage area.
14.
Put the cap on the bottle. Discard the bottle and its contents.
Attention!
To prevent print quality problems, never reuse waste developer mix.
Never put anything other than new developer mix into the developer
mix inlet.
15. Remove the cap from the new developer mix bottle.
16. Remove the developer inlet cover.
Chapter 7. Ordering and Replacing Supplies
197
|