IBM INFO PRINT 3000 - Manual (Page 291)

Table 25. Configuration Worksheet – Simplex Model (continued)
Item Available Values Selected Value
Screen Saver Timeout 0 to 60 minutes
Alarm Suppression Yes / No
Fuser Inactivity Timer 0 to 9 hours
Eject to Front Facing Yes / No
Form definition order Yes / No
Stacker Enabled Yes / No
Cut sheet emulation
v None
v Normal Left-to-Right
v Normal Right-to-Left
v Inverted Left-to-Right
v Inverted Right-to-Left
BTS Installed Yes / No
BTS Enabled Yes / No
Offsetter Installed Yes / No
Offsetter Enabled Yes / No
Offset on Mark Forms Yes / No
3130 Bar Code Compatibility Yes / No
Printer Preheat Temperature 45 to 100°C
Scan Factory Adjust (CE Change Only) N/A
Process Factory Adjust (CE Change Only) N/A
Beam 1 Offset (CE Change Only) 0.0 to 15.9 N/A
Beam 2 Offset (CE Change Only) 0.0 to 15.9 N/A
Beam 3 Offset (CE Change Only) 0.0 to 15.9 N/A
Beam 4 Offset (CE Change Only) 0.0 to 15.9 N/A
Beam 5 Offset (CE Change Only) 0.0 to 15.9 N/A
Machine Sequence (CE Change Only) N/A
Manufacturing Plant (CE Change Only) N/A
Date and Time (CE Change Only) N/A
HOST ATTACHMENTS CONFIGURATION:
Parallel Channel:
Parallel Link A Installed
Yes / No
Parallel Link B Installed Yes / No
Device Address 00 to FF (hexadecimal)
Second Channel Static / Dynamic
Data Transfer Protocol Interlocked / Data Streaming
Data Streaming Rate 1.9 / 2.7 / 3.4 / 4.5MB /sec
Card 1 Slot Position 2 / 4 / Not Installed Automatically set at power on,
cannot be changed.
Card 2 Slot Position 2 / 4 / Not Installed Automatically set at power on,
cannot be changed.
ESCON Channel:
Chapter 8. Configuring the System
259