IBM INFO PRINT 3000 - Manual (Page 253)

Table 16. Printer Configuration Items
Configuration Item Description Value Options
Printer Mode (D) This entry allows setting whether the duplex system is to
be operated in duplex or simplex (dual-simplex) mode.
(This item applies to Models ED1/ED2.)
If you change the Printer Mode, the Restart procedure
automatically executes a Shutdown procedure.
Duplex or Simplex
Auto Start If Yes, all current attachment interface status
(enable/disable) is saved during a Shutdown procedure,
and automatically restored at the next power on of the
system. Simplex and dual simplex printers are also
automatically made Ready at the completion of the
power on sequence. The Thread/Align forms procedure
must be performed on duplex printers before the system
can be made Ready.
Yes or No
PQE boldness for
printer 1
This item must not be changed.
Note: If this value is changed accidentally, set the value
to 85 and inform the CE during the next visit.
100%
PQE boldness for
printer 2 (D)
See entry for printer 1. See entry for printer 1.
Printer 1 Counter (CE Change Only) The Print Usage Count from the
mechanical counter at the rear of the printer may be
transferred to this counter, which will then become a new
base count in the running “Printer 1 Counter” displayed
in the Printer Status Display Touch Screen window.
0 to 2 000 000 000
Printer 2 Counter (D) (CE Change Only) The Print Usage Count from the
mechanical counter at the rear of the printer may be
transferred to this counter, which will then become a new
base count in the running “Printer 2 Counter” displayed
in the Printer Status Display Touch Screen window.
0 to 2 000 000 000
Printhead resolution This parameter changes the resolution that the printhead
in this printer uses. Not all values are supported on all
printers.
Valid values are 480 or 600 DPI.
The value you select depends on
what features are installed on the
printer.
IPDS Resolution This parameter can only be set when a printhead
resolution of 600 DPI is selected.
Automatic, 240 DPI, 300 DPI, or
600 DPI
Font Enhancement This parameter is used to activate or deactivate the edge
smoothing algorithm for raster fonts. Set to No if edge
smoothing is not desired.
Yes or No
Jam Recovery Type This entry controls under what conditions the host
system will automatically retransmit pages after a forms
jam has been cleared.
v
Normal Jam Repositioning - All lost pages are
automatically retransmitted and reprinted.
v Suppress All Jam Repositioning - No lost pages will be
retransmitted. Any missing or damaged pages must be
manually recovered.
v Use Normal Jam Repositioning
v Suppress All Jam Repositioning
Chapter 8. Configuring the System
221
|
|
| |
|
|