IBM INFO PRINT 3000 - Manual (Page 206)

Switching Print Resolution
Use this procedure to select the print resolution for a print job when it requires a
different print resolution than is currently in use.
Note: Do not change the print resolution in combination with any other
configuration changes. You must do it separately.
1. SELECT the Configure pull-down menu on the Display Touch Screen window.
2. SELECT the Configure Printer procedure. The Configure Printer window
appears.
3. SELECT the Printhead Resolution: XXX item, where XXX is the current print
resolution configuration. The Printhead Resolution window appears listing the
valid dots-per-inch (DPI) resolution numbers.
4. SELECT the appropriate resolution number.
If you select 600 DPI, another window appears. This window shows the current
IPDS resolution. Select the desired IPDS resolution.
5. If you select 480 DPI (or 600 DPI in combination with 240, 300, 600, or Auto
IPDS resolution), the Enhanced Fonts window appears. You must select Yes or
No for Single-byte and Double-byte Font Enhancements.
6. SELECT the OK pushbutton on the Configure Printer window. The print
resolution is now at the number you selected.
174
InfoPrint 3000 Operator’s Guide
|
|
|