IBM INFO PRINT 3000 - Manual (Page 252)

Note: The printer does not collate multiple copies. This has to be done by
hand.
c. SELECT the Print pushbutton on the Print Configuration window.
Important
The configuration data is always printed in U.S. English.
5. To change an item:
a.
SELECT it from the list. You see either a pop-up window or a keypad
window.
b.
SELECT the value you want from the pop-up window, or enter data on the
keypad window. Then SELECT the OK pushbutton.
Repeat this step for as many items as you want to change.
Note: If you are changing Printer Mode or Printhead Resolution, any other
configuration items you may be changing will change only for the
mode you are switching from. The mode you are switching to will
not have any changed configuration items.
c. When you have made all the changes, SELECT the OK pushbutton. You see
the Restart prompting window.
d. If you have other configuration changes to make, you can make them before
you restart the system. If your configuration changes are complete, SELECT
the Restart pushbutton on the Restart window to make them effective.
Printer Configuration Information
Table 16 on page 221 describes all configuration items, what each is used for, and
the allowable value options for each item. The factory-set default value options are
underlined or separately specified.
Important! Table 16 on page 221 lists all configuration items for all models of the
printers. Some items may be greyed out or not shown for your particular model of
printer:
v
Configuration items that are marked (D) appear only for Duplex systems.
v Configuration items that are marked (S) appear only for Simplex systems.
v All unmarked items appear for both Duplex and Simplex systems.
220
InfoPrint 3000 Operator’s Guide
|
|
|