Switching printer modes (dual simplex/duplex), Switching from duplex to dual simplex mode, Switching from dual simplex to duplex mode – IBM INFO PRINT 3000 User Manual
Page 204: Switching, Printer modes (dual simplex/duplex)” on
Switching Printer Modes (Dual Simplex/Duplex)
Use these procedures to switch between duplex and dual simplex modes on
Models ED1/ED2.
Note:
Do not change the print mode in combination with any other configuration
changes. You must do it separately. Make other configuration changes after
the printer is in the correct print mode.
Switching from Duplex to Dual Simplex Mode
1.
To stop the printer, SELECT the Stop pushbutton on the Display Touch
Screen.
2.
SELECT
the Configure pull-down menu on the main Display Touch Screen
window.
3.
SELECT
the Configure Printer procedure. The Configure Printer window
appears.
4.
Find and SELECT the Printer Mode item.
5.
SELECT
the Simplex item.
6.
SELECT
the OK pushbutton.
7.
SELECT Restart
when this prompt appears.
8.
A window appears that informs you that an automatic Shutdown procedure
has started. This is followed by a window that states that the system is being
“rebooted” (reloading AFCCU microcode). At the completion of the microcode
reload, the Printer Mode change is in effect (one of the main simplex printer
Display Touch Screen windows appears).
Note:
No system power-off and power-on procedure is required.
9.
To remove any forms still in the printer, see “Clearing the Forms Path” on
10.
Load paper and assign forms in both printers for dual simplex operation (see
“Loading Forms (Simplex or Dual Simplex Mode)” on page 102).
11.
SELECT
the Ready pushbutton.
For additional information, see “Chapter 8. Configuring the System” on page 217.
Switching from Dual Simplex to Duplex Mode
1.
To stop the printer, SELECT the Stop pushbutton on the Display Touch
Screen.
2.
SELECT
the Configure pull-down menu on the Display Touch Screen
window.
3.
SELECT
the Configure Printer procedure. The Configure Printer window
appears.
4.
Find and SELECT the Printer Mode item.
5.
SELECT
the Duplex item.
6.
SELECT
the OK pushbutton.
7.
SELECT Restart
when this prompt appears.
8.
SELECT
the OK pushbutton.
9.
The Second Simplex window appears. You must select the Shutdown/Restart
procedure from the Operate pull-down menu on that Display Touch Screen,
172
InfoPrint 3000 Operator’s Guide
|
|
|