IBM INFO PRINT 3000 User Manual

Page 185

– The system has gone through a “Restart” procedure with forms that are

loaded through both printers.

– You are in a recovery procedure for an error condition or a forms jam that

did not tear, damage, or separate the forms in the forms path through

both printers.

– The system power was switched off and then switched back on with

unseparated forms threaded through both printers.

Forms are not loaded in printer 2

Select this when:
– You are loading a new type of form with different characteristics from the

last form that you used in the system.

– You are loading the same type of form that you previously used in the

system; it was allowed to run out to end-of-forms; and it was flushed out

of the printer so that a new supply of forms could not be spliced to the

trailing edge of the old supply.

– You are in a forms jam recovery procedure that separated the forms in a

manner that you could not rejoin by splicing.

Forms are broken between the printers

Select this when you are recovering from a condition that separated the

forms between Printer 1 and Printer 2 that you can rejoin by splicing.

If you SELECT the Cancel pushbutton on the window, the following actions

occur:
v

If you selected this procedure from the Operate pull-down menu, the

Thread/Align Forms

procedure closes with no actions taken.

If this procedure appeared automatically, the Thread/Align Forms procedure

closes. However, any later attempt to make the printer Ready causes an

Intervention Required

Display Touch Screen window containing a “D206”

SRC to appear. This requires SELECTING the Thread/Align Forms

procedure and executing it before any printing actions can resume.

Chapter 6. Operator Responsibilities

153