IBM INFO PRINT 3000 - Manual (Page 274)

3. To add a new interface, do the following:
a.
SELECT the New Processor... pushbutton.
b.
Use the keyboard to enter the name of the interface you are adding.
c. SELECT the keyboard OK pushbutton.
d.
Change the configuration information for the new interface (see the next
step).
4.
To change the values that are assigned to an interface, do the following:
a. SELECT from the Select a Processor Name selection list box the name of
the device interface you want to change. The window shows the current
values for the device.
b.
SELECT the field you want to change.
c. SELECT the new value you want from the pop-up window, or enter data
on the keypad window and SELECT the OK pushbutton.
Repeat this step for as many items and devices as you want to change.
5. To delete a device, do the following:
a.
SELECT from the Select a Processor Name box the name of the device you
want to delete from the configured list.
b.
SELECT the Delete pushbutton.
6. SELECT the OK pushbutton on the Configure Pre/Postprocessors window
when you have finished making all changes to the pre/postprocessor
configuration.
Figure 35. Configure Pre/Postprocessors Window - Duplex Mode
242
InfoPrint 3000 Operator’s Guide