IBM INFO PRINT 3000 - Manual (Page 34)

Table 1. InfoPrint 3000 Printer Specification Summary
Model Mode
Resolution
(DPI)
Print Speed
(IPM)
Basis Paper Weights Forms Width Forms Length
g/m 2 lbs
Min. mm
(in.)
Max. mm (in.) Min. mm (in.) Max. mm (in.)
ES1 Simplex
480 1 , 600 1
480/600 2
112/172 3 60-160 16-42 204 (8) 457 (18)
76.2 ± 0.3 (3.0
± 0.013)
356 ± 0.3 (14.0 ±
0.013) 8 , 9
ED1/ED2
Duplex 4
Dual Simplex 4
480 1 , 600 1
480/600
480 1 , 600 1
480/600
224/344 3
112/172 3
60-105
60-160
16-28
16-42 7
229 (9)
204 (8)
457 (18)
457 (18)
76.2 ± 0.3 (3.0
± 0.013)
356 ± 0.3 (14.0 ±
0.013) 8 , 9
Notes:
1. Standard resolution (specify feature).
2. Optional feature.
3. Print Speed stated in 1-up mode/2-up mode. (See notes 5 and 6 for more information.)
4. The Print speed for Duplex is the total system speed (2 printers). The Print speed for dual simplex lists individual printer speed (either Printer 1 or Printer 2).
5. 1-up mode (assuming an 8½-inch length page, measured in the forms process direction).
6. 2-up mode (assuming an 11-inch length page, measured in the forms process direction).
7. The maximum paper weight for duplex printers running in simplex mode should be 160 g/m 2 (42 lb).
8. Maximum form length is 356 ± 0.3 mm (14 ± 0.013 in.) when used with the on-board stacker.
9. Maximum form length is 711 ± 0.3 mm (28 ± 0.013 in.) when used with preprocessing and postprocessing devices.
Note: The InfoPrint 3000 operates in simplex and duplex mode, depending on the model selected. (Model ES1 operates only
in simplex mode.)
An Advanced Function Common Control Unit (AFCCU) controls the printing system and is attached to the second printer
engine in the configuration. The AFCCU is based on the IBM RISC technology and includes an Extended Graphics Adaptor
(XGA) touch-screen monitor that is used as a Display Touch Screen.
Two preprocessing/postprocessing device interfaces (one in each printer), are provided on Models ES1 and ED1. This allows
input capabilities and output capabilities beyond the standard forms input source and output stacker in the system printers.
All other models are equipped with one preprocessing/postprocessing device interface as standard equipment. Your
company can purchase additional interfaces.
2
InfoPrint
3000
Operator’s
Guide