IBM INFO PRINT 3000 - Manual (Page 321)

Table 30. SRC Messages (continued)
Code Message Text Type (Printer Error unless
noted otherwise)
D21B Intelligent postprocessor failed to clear buffer
D21C PAGE COMPLETE not sent by intelligent interface
D21E Side 2 Verify has stopped checking pages
D702 Out of data while printing
D703 Printer unable to do requested command
D705 Printhead overrun while printing
D706 BEAM DETECT was not received.
D707 Loss of printer DVS (vertical sync) pulse
D70B Printhead underrun
D70C Print buffers out of sequence
D70D DVS (vertical sync) pulse frequency error
D70E Mechanism Interface Card (MIC) parity error
D70F MIC Print Quality Enhancement (PQE) error
D714 MIC timer 2 error
D715 Parity error between MIC and PQE card
D716 PQE card failed to initialize.
D717 Early ACK from intelligent postprocessor
D718 MIC failed to send frame to intelligent interface
D719 Response timeout on intelligent interface
D71A Noise on pre/postprocessor port 1
D71B Noise on pre/postprocessor port 2
D71C Noise on pre/postprocessor port 3
D71D 6 PPI sync pulse missing
D71E Scan line error while printing
D71F Side1/Side 2 mismatch
D720 Verification mark position incorrect
D721 Hardware error: verification mark sensor
D723 MIC memory failure
D724 Side 2 verify has been disabled
Chapter 10. Responding to Messages
289
||