IBM INFO PRINT 3000 - Manual (Page 281)

Setting the Preheat Platen Temperature:
The Preheat selection in the Forms Characteristics box allows you to adjust
the temperature of the preheat platen for optimum fusing of different types
of forms, such as labels or heavy-stock forms. The default temperature is
80°C, which is acceptable for regular forms.
If you are defining a form that requires a preheat platen temperature above
or below 80°C, you can enter another temperature in increments of 5°; that
is, you can enter temperatures such as 70°, 75°, 85° or 90°C. The minimum
temperature you can set is 45°C; the maximum temperature you can set is
100°C.
d. To set or change the preheat platen temperature, do the following:
v
SELECT the Preheat field. A keypad window appears.
v To use the default temperature, enter 0 (zero) on the keypad and SELECT
the OK pushbutton.
Note: The default temperature is set under the Configure Printer menu.
v To use a different temperature, enter a number between 45 and 100°C in
increments of 5 degrees (for example, 50, 55 or 60). SELECT the OK
pushbutton.
e.
When you finish making all changes to forms, SELECT the OK pushbutton
on the Define Forms window.
Operate Configure Analyze Options Help
Check Reset NPRO Cancel Job Ready
Printer Status
HC6OG082
Width
OK Delete Help
8.50
Unit
in.
mm
Define Forms
Form Description
New Form...
Letter
Cancel
Length
Select a Form Name
Form Characteristics
Standard
2UpLetter
12x18
Pinless: No
Pinless mark: Preprinted form
Printable width: Normal width
Preheat: 0
12.00 Standard 8.5 x 12 in.
Search...
Chapter 8. Configuring the System
249