IBM INFO PRINT 3000 - Manual (Page 232)

Checking the Fine Filter
Do this task when you see the following message:
CHECK FINE FILTER 0799
Note: You must do this task immediately. You cannot delay it as you can with
some Out of Supplies conditions.
1.
From the rear of the printer, open the rear center cover.
2. Ensure that the filter container is upright in the recessed filter area.
3. Ensure that the filter cover is firmly latched in place.
4.
Ensure that the filter hose is attached to the filter cover.
5. Close the rear center cover of the printer.
6. To resume processing, SELECT the Ready pushbutton on the main Display
Touch Screen.
7. If the CHECK FINE FILTER message appears again, repeat steps 2 through 6. If
that still does not correct the problem, contact your service representative. See
“Service Call Procedure” on page 13 for instructions.
200
InfoPrint 3000 Operator’s Guide