IBM INFO PRINT 3000 - Manual (Page 173)

5. Press and hold the puller lever down.
6.
Grasping the forms near the fuser entry area, pull them up and out of the fuser.
(This moves the forms in the opposite direction from their usual path.)
7.
If the forms will not pull up, or if some forms remain in the pendulum, do the
following:
a.
Lower the stacker table.
b. Open the stacker gate.
c. Grasp both sides of the forms and pull down evenly.
d.
Close the stacker gate.
e. Raise the stacker table.
Chapter 6. Operator Responsibilities
141