IBM INFO PRINT 3000 - Manual (Page 310)

Status Messages
Status messages describe the condition of a printer or the system. Sometimes they
are a response to operator action.
Status messages are only for your information and do not necessarily mean that
something is wrong. However, if a printer is not performing the way you think it
should, a status message can give you a clue about what to do.
Figure 42 shows a sample Printer Status window. The Printer Status window
automatically appears when the system is powered-on. If you have closed the
window, you can see it again by SELECTING Printer Status from the Operate
pull-down menu.
The window contains the following:
v
Printer Status 2
– In duplex mode, this field displays a 2-line overall system status.
SELECTING this field displays more detailed information about both printers
and their preprocessing/postprocessing device interfaces.
– In simplex mode, this field displays a 2-line status for the individual printer.
SELECTING this field displays more detailed information about the printer
and its preprocessing/postprocessing device interfaces.
The status messages that may appear in each line in this field are shown in
Table 29 on page 279.
v Attachments Status 1
This field contains a line of status for each installed host system interface.
v System Status 3
This field contains:
– An overall system attachments status.
HC
6OG092
Operate Configure Analyze Options Help
Check Reset NPRO Cancel Job Ready
Attachments Status
Messages
Reset
Counter
Help
Not Ready
Tracing
Parallel Channel A: Disabled
Parallel Channel B: Disabled
Printer Error: D205
Printer Status
No Attachments Enabled
Printer 1 Counter: 135 Feet
Printer 2 Counter: 135 Feet
Reset Counter : 4 Feet
Printhead resolution: 600
1
2
3
Figure 42. Printer Status Window
278
InfoPrint 3000 Operator’s Guide