Grass Valley Kayenne v.3.0 - Manual (Page 432)

432 KAYENNE — User Manual
Section 3 — System Operation
Figure 275. Position Menu
1. Touch the image you wish to re-position.
2. Touch the Position data pad to display the Position menu ( Figure 275 ).
3. Touch the Horizontal (X) or Vertical (Y) data pads ( Figure 275 ) and enter a
value in the keypad to change the image position, then press Enter , or
use the Menu Panel soft knobs to adjust the image position.
4. Touch the Confirm Position button to complete the change in position and
close the Position menu ( Figure 275 ).
Freeze Mode
Freeze Mode can be set to Frame, Field 1, or Field 2 using the Frame , Field 1
or Field 2 buttons. This is very useful if you need to eliminate motion flicker
or artifacts from an image. To set the Freeze Mode ( Figure 276 ):
1. Touch an image from the scrolling list.
2. Touch the Freeze Mode button.
3. Viewing the image on a monitor, touch the Frame / Field 1 / Field 2 buttons
to change the mode for the best image.
4. Touch the Confirm button.