Grass Valley Kayenne v.3.0 - Manual (Page 365)

KAYENNE — User Manual 365
ME Split Mode Operation
Control Panel Controls
Control Panel ME Partition Delegation
When an ME has been split, the Pri and Sec delegation buttons on that ME
are activated.
Pri and Sec Delegation Buttons
The Pri and Sec buttons delegate the source selection buses, Transition
Module, and Local E-MEM Module of that ME to the selected partition.
Pressing one of the
Pri and Sec buttons deselects the other. At least one par-
tition is always selected on a split ME.
Delegating Both Partitions
Holding down one of the Pri and Sec buttons and pressing the other dele-
gates both partitions. When the panel is delegated to both partitions, the
E-MEM and Transition Modules control both partitions simultaneously.
Also, the button tally indicators in the Transition Module and the transition
pattern shape displayed in the ME Status display reports information for
only the Primary partition.
Source Selection
When an ME is split and its Control Panel controls are delegated to only the
Secondary partition, the alternate buses for that ME are reversed. Keyer 3
and Keyer 4 sources are selected on the keyer buses and Util 1 and Util 2
sources are selected on the background buses by default. Holding down the
delegation buttons allows source selection on the other Keyer 1, Keyer 2,
Bkgd A and Bkgd B buses. This works well for the typical situation where
an ME is split into equal partitions, with Keyer 1 and 2 assigned to the
Primary partition and Keyer 3 and 4 assigned to the Secondary partition.
If both partitions are delegated, source selection behaves the same as when
only the Primary partition has been delegated.
ME Partition Preview
Preview outputs are available for both partitions of a Split ME. The ___ MxpA
output of each bank is used for the Primary partition preview, and the ___
Mxp2 output is used for the Secondary partition preview. These preview
signals can be mapped to output connectors with the Output Assignments
menu, accessed by touching
Eng Setup , Outputs .
You can preview ME partitions on switched preview using the System Bar.
Hold down the
Sec PVW button while making the selection to view the Sec-
ondary partition preview of an ME.