Grass Valley Kayenne v.3.0 - Manual (Page 410)

410 KAYENNE — User Manual
Section 3 — System Operation
With the Video Thumbnail Viewer selected, you can test the composite ele-
ments using the motion control buttons.
Make the Sub-clip
1. Touch the Make Clip button.
2. Enter the name of the new clip and touch Enter .
The new clip is created and appears in the clip lists in the ClipStore menus.
Note If Multiple sub-clips are desired from a built clip, use Build Edit to make the
whole clip and then use the Cut Edit to make multiple sub-clips.
Adding a New Audio Element with Build Edit —If you require audio before or after
video, a video track (for example of black) is needed so a mark can be made
(this can be added with Join Edit, see Join Edit
on page 413 ).
In this case, use the Video and Key of the loaded Video track but
add/replace the Audio track and make a sub-clip. The
Use Key From Video
button is enabled (highlighted green):
1. Unless the desired clip is loaded, touch the Video Thumbnail Viewer
( Figure 256 ).
Figure 256. Build Edit Mode—Audio Track Edit
2. Touch the Change Clip button for the Video and touch the desired clip
( Figure 256 ).