Grass Valley Kayenne v.3.0 - Manual (Page 304)

304 KAYENNE — User Manual
Section 3 — System Operation
Definable sub-levels can also be part of the copied register.
Copy/Swap with the Multi-Function Module
Use the Copy and Swap mode buttons in the Multi-Function Module to enter
those modes and copy or swap ME, Keyer, and e-DPM settings between
MEs (
Figure 204 ).
The Wipe , Matt , and DPM buttons can be turned on and off (default is on) in
the MFM. With an ME and keyer selected in either Copy or Swap menu del-
egations, the buttons will be available therefore you can include/exclude
those parameters from the copy/swap operations.
Figure 204. Copy Swap—Multi-Function Module
ME Copy/Swap
In Copy or Swap mode, the ME/Keyer/e-DPM sources are selected from
the source buttons in the top two button rows in the MFM and destinations
are selected in the bottom two rows (
Figure 204 ).
Note ME Keyers can be copied/swapped with e-DPM channels and vice versa.
To Copy an ME:
1. From the Home mode in the Multi-Function Module, press the Copy
button.
2. Select the Source ME/Key ( Figure 204 ).
3. Select the Destination ME/Key ( Figure 204 ).
4. Press the Copy button (below the joystick).
Wipe ipe
1
Key Key
5
Key Key
3
Key Key
1
Wipe ipe
2
Key Key
6
Key Key
4
Key Key
2
ME1 Adel Last
K1 K5 K6 K4 K3
8623267_15_
r1
Copy Swap Undo
ME2 ME3 ME4 PGM eDPM
K2
ME1 Home ME2 ME3 ME4 PGM eDPM
SOURCE
SOURCE
DESTIN.
DESTIN.