Grass Valley Kayenne v.3.0 - Manual (Page 354)

354 KAYENNE — User Manual
Section 3 — System Operation
Router Control of Aux Busses
The Kayenne can be configured to allow Encore and Prelude control sys-
tems, including standalone Prelude Control Panels, to control Aux bus
source selections.
All switcher Aux buses can be configured to appear on the Router Control
System. Aux buses that are not enabled for router control are seen as being
‘protected’ by the switcher to the Router Control System. In other words,
an Aux bus’ current status (source selection) is displayed but it cannot be
controlled by the Router Control System.
If an Aux bus is enabled for router control, then the source can be changed
by a configured Router Control Panel.
Note Prelude Control Systems are limited to selecting the first 128 switcher
sources.
Operation
Aux busses are enabled for control in the Eng Setup, Outputs menu
(
Figure 226 ).
Figure 226. Eng Setup, Outputs Menu, Router Control of Aux Busses