Grass Valley Kayenne v.3.0 User Manual
Page 174
174
KAYENNE — User Manual
Section 3 — System Operation
Using Key Cut/Auto Buttons
Pressing any of the
K1 Cut - K6 Cut
or
K1 Auto - K6 Auto
buttons in the Transition
Module of an ME, with those keyers as part of a chain, will result in the fol-
lowing:
•
Chained keyers on the same or different MEs all transition simultane-
ously,
•
The transition rate of the button that is pressed (controlling keyer) is
applied to all the other (controlled) keyers in the chain.
Key Chaining on a Single ME
(in blue), in the Chain parameter data pads, the fol-
lowing three key chains have been created for ME 1:
•
Chain 1—Keys 1 and 2,
•
Chain 2—Keys 3 and 4, and
•
Chain 3—Keys 5 and 6.
Figure 119. Key Chaining Menu—Single ME Key Chaining
Selecting keyers in the Next-Transition section of the Control Panel will
make those keyers initiators for the transition. Key Chaining causes the
chained (controlled) keyers to be selected as well. These chained keyers will
flash to indicate they are in the chain. The keys which do not flash are the