Grass Valley Kayenne v.3.0 - Manual (Page 353)

KAYENNE — User Manual 353
Router Interface Operation
changing that source’s output signal. If an exact match is not found for the
name entered, no change will occur.
Protection
The Router Protection pane (middle) provides protection controls. These
controls are used to send commands to the external router to protect or un-
protect the router destination associated with the selected switcher source.
The button for the current setting of the selected switcher source will be
highlighted. The following protections are available:
• Protection Off – Source can be changed at any time by any control panel,
• Protection Off All Destinations – Same as Protection Off but for all destina-
tions.
• Protection On – Source cannot be changed by another control panel, but
may be changed from the Kayenne system,
• Protection On All Destinations – Same as Protection On but for all destina-
tions.
• On Air Protection – The source cannot be changed by another control panel
when it is on-air, but may be changed manually from the Kayenne
system. The source will also not be changed by an R-MEM recall, and
• On Air Protection All Destinations – Same as On Air Protection but for all des-
tinations.
External router system panels can place protections on router destinations. The first panel
placing a protection controls that destination. The Kayenne system will not be able to change
router sources feeding router destinations protected from another panel, and vice versa.