Grass Valley Kayenne v.3.0 - Manual (Page 173)

KAYENNE — User Manual 173
Transitions
Keyers are controlled from the Transition Module on the Kayenne Control
Panel. They can be cut on/off or transitioned on/off using the dedicated
Key Cut and Auto buttons. Key chaining allows for a single button push to
transition all the keys in the chain. A single keyer selection in the Next-
Transition area of the Module will similarly cause the other keys in the
chain to be selected. Then a single push of the Auto button or movement of
the Lever Arm will cause all of the keys in the chain to transition on one or
more MEs simultaneously.
Creating Chains
To create a Key Chain or chains in a single ME, simply touch a Chain
parameter data pad (Chain 1, Chain 2, etc., see
Figure 118 ) to select it (turns
blue), and touch the keys you wish to add to the chain. Touch another
Chain parameter data pad and repeat the process (for the same ME in this
case).
The Chain parameter data pads display each ME and either dashes (if
empty) or Keys 1-6 if keys are enabled for that ME in the chain (
Figure 118 ).
Figure 118. Key Chaining Menu
Once a keyer is enabled as part of a chain, the button is grayed out as each
key can only be part of one chain.
The Release ME Keys and Release All Keys buttons are provided to help manage
Key Chain configuration.