Grass Valley Kayenne v.3.0 - Manual (Page 331)

KAYENNE — User Manual 331
Device Control Operations
Q-MEM
Q-MEM can be used to assign a device to a letter button on the DCM
(
Figure 216 ), load a named clip on that device and cue to its mark-in point,
and optionally play or loop the clip. Multiple devices can also be loaded
and cued using the “Link Cue” feature.
Each suite has 1000 cue memory registers (Q-MEMs).
Each cue has:
• Up to 38 devices with associated device state data (device state),
• Up to 6 device associations with device control buttons A - F ,
• Selection of radio buttons A - F (or none) (device selection), and
• One play flag.
For each device, the following device state data is learned into the cue:
• Clip name,
• Mark-In point for clip,
• Mark-out point (may be empty),
• Loop flag,
• Gang flag, and
• A list of ganged devices.
Recalling a cue register can be used to:
• Associate devices with the lettered buttons only, so you can set up your
DCM for manual use,
• Recall and cue devices without affecting the current letter button selec-
tions, and
• Both associate the devices with letter buttons and load, cue, and play
them.