Grass Valley Kayenne v.3.0 - Manual (Page 379)

KAYENNE — User Manual 379
Macros
Post-Attach a Macro
1. Delegate the bus rows to Macro by pressing the Macro button (see
Figure 232 on page 375 ).
2. Press and hold down the keyer row button to which the macro is to be
attached.
3. Press the macro button to be attached (if Show Attach is on, the newly
defined macro button will flash until Show Attach is turned off).
Note Macros attach to physical buttons, not to the delegated target of that button.
This means, for example, if you attach a macro to the Chroma Key button,
pressing that button runs the macro regardless of which keyer the Transition
Module has been delegated to control.
To attach multiple macros to the same button, select another attach mode,
then select the macro register of the additional macro, then touch the button
to which you wish to attach it. Up to three macros (one of each type) can be
attached to the same button.
Attaching a Macro Using the Menu
1. Go to the Macros Attach menu (touch Macros , Attach ) ( Figure 234 .
Figure 234. Macros Attach Menu