Grass Valley Kayenne v.3.0 - Manual (Page 215)

KAYENNE — User Manual 215
iDPM Operations
iDPM Operations
Kayenne has two types of DPMs (Digital Picture Manipulator) options
available, iDPMs (Internal) that are available by floating license on the first
four keyers of each ME for a maximum of sixteen (on a 4-ME system) and
eDPMs (Extended), four combined or independent DPM channels that can
be mapped to separate source select buttons or delegated to any of the six
keyers on any ME (see eDPM Operations
on page 262 ).
If any iDPM channels less than the maximum are licensed, then those iDPM
channels can be used on any of the first four keyers of an ME. For example,
if you only have two floating iDPM Channels licensed on a 2-ME system,
the two iDPM Channels can be assigned to two of Keyers 1-4 on one ME or
one keyer on each of the two MEs.
Note iDPMs and eDPMs are software options (and also hardware in the case of
eDPM) and must be enabled in the Eng Setup, Install Options menu when
purchased.
iDPMs can be activated and controlled in the Menu Panel and the MFM
(Multi-Function Module). Most but not all of the functions are common.
Multi-Function Module
The MFM in the Kayenne Control Panel can be delegated to activate and
control iDPM Channels.
Delegation
Delegate the MFM to the desired ME by pressing any of the keyer function
buttons (right side) on the Source Select Module of that ME. Alternatively,
you can press the ME soft button to select the ME and then press the desired
keyer hard buttons on the MFM (for multiple keyer button selection, hold
down one keyer button then select the rest or press them all simultane-
ously).
1. Press the iDPM button (On/Off toggle button; on is white) from Home
on the MFM or Press the Key button.
2. Press the iDPM button in the iDPM/Key Mode ( Figure 142 ). This will
delegate the MFM to iDPM and enable iDPM for all selected keyers.