Grass Valley Kayenne v.3.0 - Manual (Page 412)

412 KAYENNE — User Manual
Section 3 — System Operation
Figure 257. Build Edit Mode—Key Track Edit
2. Touch the Change Clip button for the Video and touch the desired clip
( Figure 257 ).
3. Determine where you want a mark-in point for the Video track by
either playing/jogging to the mark while viewing the clip on a monitor
and touching the
Mark In button ( Figure 257 ) or if you know the
timecode, touch the Mark In data pad and enter the timecode into the
pop-up keypad, and touch Enter .
4. Determine the mark-out point for the Video track and enter it as
described for Mark In.
5. Synchronize the Key track in relation to the current video track
timecode position, if needed, using the
Hold Sync data pad or the Key
Offset soft knob (see page 407 for more about Hold Sync).
With the Video Thumbnail Viewer selected, you can test the composite ele-
ments using the motion control buttons.
Make the sub-clip
1. Touch the Make Clip button.
2. Enter the name of the new clip and touch Enter .