Nable button, Figure 203 – Grass Valley Kayenne v.3.0 User Manual
Page 303
KAYENNE — User Manual
303
Copy/Swap
Figure 203. Copy Swap Timeline sub-level Selection
For example, ME2 Pri, Effect Register 1, has two keyers with iDPM param-
eter settings you want as part of an effect (
) but you want to use
those sub-levels with the parameter settings in Effect Register 0, on ME1
Pri. One way to accomplish this is to copy the Keyer/iDPM sub-level infor-
mation of Effect ME2 Pri, Effect Register 1, to Register 0, on ME1 Pri:
1.
Touch the
From Effect Number
data pad (
) and enter the effect
register number you want to copy ‘from’ in the Enter Source Register
pop-up keypad.
2.
Touch the
To Effect Number
data pad (
) and enter the effect
register number you want to copy ‘to’ in the Enter Destination Register
pop-up keypad.
3.
With the
Include All Sublevels
button off, touch the
Keyer 3
,
Keyer 4
,
iDPM 3
and
iDPM 4
sub-level buttons to turn them on (alternatively, you can
turn on Include All sub-levels and individually touch each sub-level to
disable them).
4.
Touch the
Copy
button.
5.
Recall the destination register to see the result (touching the Copy
button does not trigger a recall).
The result is that only Keyer 3, Keyer 4, iDPM 3, and iDPM 4 are copied to
Register 0, on ME1 Pri. All other effect parameter settings are the same.