Grass Valley Kayenne v.3.0 - Manual (Page 194)

194 KAYENNE — User Manual
Section 3 — System Operation
4. Perform the desired relative or absolute modify operation:
• To make relative changes, access the Timeline Edit menu by
touching
E-MEM & Timeline , Timeline Edit , then touch the Mod All Relative
button. The relative changes of the modified parameters will be
applied to all the affected keyframes in the effect.
• To make absolute changes, access the Timeline Edit menu by
touching
E-MEM & Timeline , Timeline Edit , then touch the Mod All Absolute
button. The absolute values of the modified parameters in the work
buffer will be applied to all the affected keyframes in the effect.
E-MEM Learn Auto Recall
Each E-MEM register contains header information, along with keyframe
data. This header information applies to the entire effect and is not key-
framable. Register header information includes:
• E-MEM enable group button selections (for Auto Recall)
• Effect Dissolve state (on or off)
• Effect Dissolve rate (seconds, frames, field)
When an effect is edited in the standard manner (Insert Before/After,
Modify Keyframe, Modify All), only keyframe data is affected. The header
information does not change. In a standard Learn operation, all existing
keyframe data is overwritten with a single keyframe, and new header
information is saved.
Learn Auto Recall can be used to update E-MEM register header informa-
tion without changing keyframe data. To use this feature, select the state of
the desired header information, press
LRN (top left soft button ) then Auto
Recall (top left hard button) on the Master E-MEM module. Examples are
presented below:
To change the enable groups associated with Auto Recall:
Press Auto Recall so it is on, select the desired Master E-MEM Module Enable
buttons for the desired groups of levels, then press LRN , Auto Recall .
To set or change the Effect Dissolve rate:
Press LRN , DIS , RATE , on the Master E-MEM Module, type seconds, frames,
or fields, then press the button for the register you wish to apply the effect
dissolve rate.
Editing Path Control
Path control determines how interpolation is performed through key-
frames. S-Linear, Linear, and Curve path types are supported, in addition