Grass Valley Kayenne v.3.0 - Manual (Page 351)

KAYENNE — User Manual 351
Router Interface Operation
The Router button on the Control Panel (Source Select Modules) is pressed
to place the Control Panel in Router Assign mode. When pressed all normal
panel operation is disabled, replaced with Router assign functions.
The source select buttons are used to choose the switcher source to change,
and then the desired router source is selected (same as the Local Aux
Module). Up to 32 router sources can be displayed at a time (per Shift
Level).
The last two buttons on the right of each bus provide PREV and NEXT Page
functions, allowing additional groups of router sources to be displayed on
each bus of the Control Panel.
Direct router group selection is not available on the Control Panel.
Operation
The router source selection process on the Control Panel is essentially the
same as the Local Aux Module.
1. Press the Rtr button on the Local Aux Module to enter Router Assign
Mode.
2. Press a source selection button to choose the desired switcher source,
using the Shift Level buttons if necessary.
3. Press the router source button for the chosen switcher source, using the
PREV and NEXT buttons if necessary.
4. After selecting a routed source, the system returns to Step 2 and you
can select another switcher source to change.
Menu Panel Router Interface Operation
The Router Control menu provides a way to directly change router sources
from the Menu Panel. The Router Select menu is reached by pressing the
R-MEM Menu Panel button, then touching the Router Control category selec-
tion button ( Figure 225 ).