Grass Valley Kayenne v.3.0 - Manual (Page 110)

110 KAYENNE — User Manual
Section 3 — System Operation
Stripe and PGM PST is available for exchange (delegation) on each Stripe’s
Exchange ME button.
For Kayenne systems with more than one additional ME than available
Stripes, an ME can be preassigned to the
Exchange ME button by holding
down the button and selecting the ME for exchange on the Local E-MEM
Module. Only one ME for exchange can be assigned at a time.
The Exchange ME button displays the color of the unassigned ME. For the
example above with PGM PST and ME-4, when PGM PST is red and ME-4
is purple, after ME-4 is exchanged with PGM PST the
Exchange ME button
changes from purple to red (for each Exchange ME button on all Stripes in that
suite).
Automatic Delegation
With the ADel button toggled on in the Multi-Function Module, when an
operator activates any object on a Stripe, the Multi-Function Module will
automatically delegate to control the specific object involved. For example,
selecting a key for the next transition, automatically delegates the other
modules in that Stripe, and the Multi-Function Module to control that
keyer. Automatic delegation only occurs when the operator presses a
button on a Stripe, and does not occur if the panel’s state is changed by an
external interface, like an edit controller.
Automatic delegations can be quickly disabled at any time on the Multi-
Function Module by toggling the
ADel button to off.
Multiple Keyer Delegations
The ME Keyer Delegation buttons on the Multi-Function Module can dele-
gate the Keyers, Mattes, and Masks to more than one keyer. If the Multi-
Function Module’s controls have been delegated to multiple keyers, the
Multi-Function Module delegation buttons will go off, to indicate a single
keyer is not being controlled. The remaining Multi-Function Module
buttons can only display status for one of the keyers (the first one pressed).
Any changes made will be applied to all the keyers involved. Any context
sensitive delegation inside the Multi-Function Module will be based on the
first keyer selected. For example, if Key 1 is a Chroma Key and Key 2 is a
Preset Pattern, adjusting Clip should change the clip for both Key 1 and
Key 2. However, since Key 2 does not use Clip (being a Preset Pattern) it is
unaffected. The size of the Preset Pattern will not change.
Similarly, in the Source Select Module, you can select and hold down mul-
tiple keyer delegation buttons, then select a source, and that source will be
selected for all keyers in the selection. The multiple selection is applied to
the Multi-Function Module.