Grass Valley Kayenne v.3.0 - Manual (Page 339)

KAYENNE — User Manual 339
Device Control Operations
Loading Clips
External devices are controlled using various protocols (BVW, Odetics,
AMP). These protocols have different capabilities, and specific models of
external devices may support only specific protocols. The exact clip loading
procedures, if available, will vary depending on the device model and pro-
tocol being employed.
In general, clips are loaded from the Devices Control menu by touching the
Program Clip data pad in a device control pane, and then selecting the clip
from the list displayed.
Clip Directory (AMP Protocol)
On the Devices Control menu, touching a Preset Clip or Program Clip data pad
brings up a menu from which you can select the desired folder and then
choose a clip in that folder to load for playback (
Figure 220 ). A similar
menu is used with the Clip Browser on the Devices Event List menu, and
for loading clips in the Timeline Events menu.
The Kayenne Multi-Function Module and Device Control Module always
show the clip list of the last selected folder.
If you change a clip locally on the Profile DDR, that clip name will be
updated on the Kayenne Devices menus. If the folder list or clip list are
incomplete, re-enabling the device will fetch the entire folder and clip list.
Note Do not create file or folder names that have the pound character ( # ) along
with either the dash ( - ) or underscore ( _ ) character, and avoid blank spaces
(for example, use “DeadEnd” not “Dead End”. This can inhibit clip access.
Note A maximum of 20 folders is recommended along with a maximum of 20 clips
per folder.