Grass Valley Kayenne v.3.0 - Manual (Page 139)

KAYENNE — User Manual 139
Source Patching
Multiple Suites and Source Names
Different sets of these alternative source names are defined for each
Kayenne suite. Ensure the Kayenne Menu Application you are using is
logged into the correct suite (
Eng Setup , Eng Logon ). The same set of engi-
neering names will be used by both Kayenne suites, however.
Name Display Hierarchy
If a source’s engineering name is left blank, the Eng ID number will be
used. If no alternative names are defined for that source, then that Eng ID
number will appear on all the Kayenne system displays.
If an engineering name has been entered (see Kayenne Installation & Service
Manual) then the engineering name will be displayed on all the Kayenne
system displays, including menus. Engineering names will be truncated to
the character limits of the display, starting with the first character.
For alternative names entered in the User Setups, Suite Prefs, Source Patch
menu (
Figure 100 ), the following rules apply:
For the three editable columns: Panel Name , OLED Name , and Menu Name , if any
of the three are left blank for that source, the first name to the left appears
in that display on the system (if all three are left blank, the name in the Eng.
Source Column is displayed). For example, if an alternative name is entered
in the OLED Name column for a source and the other two columns remain
blank, the Menu Name takes the OLED Name (OLED Name being first to
the left of the Menu Name) but the Panel Name takes the Eng. Source
column’s name (first name to its left). If names are entered in all three alter-
native name columns, each area of the system displays the name entered in
each column of the Source Patch menu (
Figure 100 ).