H3C Technologies H3C S3100 Series Switches - Manual (Page 950)

1-4
Configuration Tasks
Table 1-1 Smart Link configuration tasks
Task Remarks
Create a Smart Link group
Add member ports to the Smart Link group Configuring a Smart Link
Device
Enable the function of sending flush messages in the
specified control VLAN
Required
Configuring Associated
Devices Enable the function of processing flush messages
received from the specified control VLAN
Required
Configuring a Smart Link Device
A Smart Link device refers to a device on which Smart Link is enabled and a Smart Link group is
configured, and that sends flush messages from the specified control VLAN. A member port of a Smart
Link group can be either an Ethernet port or a manually-configured or static LACP aggregation group.
You can configure a port or a link aggregation group as a member of a Smart Link group.
Table 1-2 Configure Smart Link (with ports as the members of the Smart Link group)
Operation Command Remarks
Enter system view system-view —
Create a Smart Link group
and enter Smart Link group
view
smart-link group group-id Required
Enable the function of sending
flush messages in the
specified control VLAN
flush enable control-vlan
vlan-id
Required
By default, no control VLAN for
sending flush messages is
specified.
Smart Link
group view
port interface-type
interface-number { master |
slave }
quit
interface interface-type
interface-number
Configure a
port as a
Smart Link
group
member
Ethernet port
view
port smart-link group group-id
{ master | slave }
Required
Use either approach
Table 1-3 Configure Smart Link (with link aggregation groups are the members of the Smart Link
group)
Operation Command Remarks
Enter system view system-view —
Create a Smart Link group and
enter Smart Link group view
smart-link group group-id Required