H3C Technologies H3C S3100 Series Switches - Manual (Page 295)

2-8
Operation Command Remarks
Configure a multicast group filter
igmp-snooping group-policy
acl-number [ vlan vlan-list ]
Optional
No group filter is configured by
default, namely hosts can join any
multicast group.
z A port can belong to multiple VLANs, you can configure only one ACL rule per VLAN on a port.
z If no ACL rule is configured, all the multicast groups will be filtered.
z Since most devices broadcast unknown multicast packets by default, this function is often used
together with the function of dropping unknown multicast packets to prevent multicast streams from
being broadcast as unknown multicast packets to a port blocked by this function.
z The configuration performed in system view takes effect on all ports of the switch if no VLAN is
specified; if one or more VLANs are specified, the configuration takes effect on all ports in the
specified VLAN(s).
z The configuration performed in Ethernet port view takes effect on the port no matter which VLAN it
belongs to if no VLAN is specified; if one or more VLANs are specified, the configuration takes
effect on the port only if the port belongs to the specified VLAN(s).
Configuring the Maximum Number of Multicast Groups on a Port
By configuring the maximum number of multicast groups that can be joined on a port, you can limit the
number of multicast programs on-demand available to users, thus to regulate traffic on the port.
Table 2-10 Configure the maximum number of multicast groups on a port
Operation Command Remarks
Enter system view system-view —
Enter Ethernet port view
interface interface-type
interface-number
—
Configure the maximum number of
multicast groups allowed on the
port igmp-snooping group-limit limit
[ vlan vlan-list
[ overflow-replace ] ]
Required
For the S3100-SI series, the
system default is 256.
For the S3100-EI series, the
system default is 512.