H3C Technologies H3C S3100 Series Switches - Manual (Page 95)

2-4
To do… Use the command… Remarks
Enter system view system-view —
Enter VLAN view vlan vlan-id
Required
If the specified VLAN does not exist, this
command be created first creates the VLAN
before entering its view.
Add an Access port to the
current VLAN
port interface-list
Required
By default, system will add all ports to VLAN 1.
Follow these steps to configure the Access-port-based VLAN in Ethernet port view:
To do… Use the command… Remarks
Enter system view system-view —
Enter Ethernet port view
interface interface-type
interface-number
—
Configure the port link type as
Access
port link-type access
Optional
The link type of a port is Access by
default.
Add the current Access port to a
specified VLAN
port access vlan vlan-id
Optional
By default, all Access ports belong
to VLAN 1.
To add an Access port to a VLAN, make sure the VLAN already exists.
Configuring a Hybrid-Port-Based VLAN
A Hybrid port may belong to multiple VLANs, and this configuration can only be performed in Ethernet
port view.
Follow these steps to configure the Hybrid-port-based VLAN:
To do… Use the command… Remarks
Enter system view system-view —
Enter Ethernet port view
interface interface-type
interface-number
—
Configure the port link type as
Hybrid
port link-type hybrid Required
Allow the specified VLANs to pass
through the current Hybrid port port hybrid vlan vlan-id-list
{ tagged | untagged }
Required
By default, all Hybrid ports only
allow packets of VLAN 1 to pass.
Configure the default VLAN of the
Hybrid port
port hybrid pvid vlan vlan-id
Optional
VLAN 1 is the default by default