H3C Technologies H3C S3100 Series Switches - Manual (Page 803)

1-17
Log Output to the Console
Network requirements
The switch sends the following information to the console: the log information of the two modules ARP
and IP, with severity higher than “informational”.
Network diagram
Figure 1-3 Network diagram for log output to the console
Configuration procedure
# Enable the information center.
system-view
[Switch] info-center enable
# Disable the function of outputting information to the console channels.
[Switch] undo info-center source default channel console
# Enable log information output to the console. Permit ARP and IP modules to output log information
with severity level higher than informational to the console.
[Switch] info-center console channel console
[Switch] info-center source arp channel console log level informational debug state off trap
state off
[Switch] info-center source ip channel console log level informational debug state off trap
state off
# Enable terminal display.
terminal monitor
terminal logging
Configuration Example
Network requirements
z The switch is in the time zone of GMT+ 08:00:00.
z The time stamp format of output log information is date.
z UTC time zone will be added to the output information of the information center.
Network diagram
Figure 1-4 Network diagram
Configuration procedure
# Name the local time zone z8 and configure it to be eight hours ahead of UTC time.
clock timezone z8 add 08:00:00