H3C Technologies H3C S3100 Series Switches - Manual (Page 40)

2-8
After the above configuration, you need to modify the configuration of the terminal emulation utility
running on the PC accordingly in the dialog box shown in Figure 2-4 to log into the switch successfully.
Console Port Login Configuration with Authentication Mode Being
Password
Configuration Procedure
Table 2-5 Console port login configuration with the authentication mode being password
Operation Command Description
Enter system view system-view —
Enter AUX user interface view user-interface aux 0 —
Configure to authenticate users
using the local password authentication-mode
password
Required
By default, users logging into a switch
through the Console port are not
authenticated; while those logging in
through Modems or Telnet are
authenticated.
Set the local password
set authentication
password { cipher |
simple } password
Required
Set the baud
rate
speed speed-value
Optional
The default baud rate of an AUX port (also
the Console port) is 9,600 bps.
Set the check
mode
parity { even | none | odd }
Optional
By default, the check mode of a Console
port is set to none, that is, no check bit.
Set the stop
bits
stopbits { 1 | 1.5 | 2 }
Optional
The default stop bits of a Console port is 1.
Configure the
Console port
Set the data
bits
databits { 7 | 8 }
Optional
The default data bits of a Console port is 8.
Configure the command level
available to users logging into
the user interface
user privilege level level
Optional
By default, commands of level 3 are
available to users logging into the AUX user
interface.
Make terminal services available
to the user interface
shell
Optional
By default, terminal services are available
in all user interfaces.
Set the maximum number of
lines the screen can contain screen-length
screen-length
Optional
By default, the screen can contain up to 24
lines.
You can use the screen-length 0
command to disable the function to display
information in pages.
Set history command buffer size
history-command
max-size value
Optional
The default history command buffer size is
10. That is, a history command buffer can
store up to 10 commands by default.