H3C Technologies H3C S3100 Series Switches - Manual (Page 883)

1-15
To do… Use the command… Remarks
Configure the destination
port
destination-port
port-number
Required in a Tcpprivate test
A Tcppublic test is a TCP connection test on
port 7. Use the hwping-server tcpconnect
ip-address 7 command on the server to
configure the listening service port; otherwise
the test will fail. No port number needs to be
configured on the client; any destination port
number configured on the client will not take
effect.
By default, no destination port number is
configured.
Configure the source IP
address
source-ip ip-address
Optional
By default, the source IP address is not
specified.
Configure the source port source-port port-number
Optional
By default, no source port is specified.
Configure the number of
probes per test
count times
Optional
By default, one probe is made per time.
Configure a test description description string
Optional
By default, no description information is
configured.
Enable history record history-record enable
Optional
By default, history record is not enabled.
Configure the maximum
number of history records
that can be saved
history-records number
Optional
By default, the maximum number is 50.
Configure the retaining time
of history record
history keep-time keep-time
Optional
By default, the retaining time of history record
is 120 minutes.
Configure statistics interval
and the maximum number
of retained statistics
information
statistics { interval interval |
max-group number }
Optional
By default, statistics interval is 120 minutes
and up to two pieces of statistics information
can be retained.
Configure the retaining time
of statistics information
statistics keep-time keep-time
Optional
By default, the retaining time of statistics
information is 120 minutes.
Configure test start time
and lifetime
test-time begin { hh:mm :ss
[ yyyy/mm/dd ] | now } lifetime
lifetime
Optional
By default, no test start time and lifetime is
configured.
Enable routing table bypass sendpacket passroute
Optional
By default, routing table bypass is disabled.
Configure the TTL ttl number
Optional
By default, TTL is 20.
The sendpacket passroute command voids
the ttl command.
Configure the probe timeout
time
timeout time
Optional
By default, a probe times out in three
seconds.
Configure the automatic
test interval
frequency interval
Optional
By default, the automatic test interval is zero
seconds, indicating no automatic test will be
made.