H3C Technologies H3C S3100 Series Switches - Manual (Page 137)

1-6
Table 1-2 Relations between the timers
Timer Lower threshold Upper threshold
Hold 10 centiseconds
This upper threshold is less than or
equal to one-half of the timeout time of
the Join timer. You can change the
threshold by changing the timeout time
of the Join timer.
Join
This lower threshold is greater than or
equal to twice the timeout time of the Hold
timer. You can change the threshold by
changing the timeout time of the Hold
timer. This upper threshold is less than
one-half of the timeout time of the Leave
timer. You can change the threshold by
changing the timeout time of the Leave
timer.
Leave
This lower threshold is greater than twice
the timeout time of the Join timer. You can
change the threshold by changing the
timeout time of the Join timer. This upper threshold is less than the
timeout time of the LeaveAll timer. You
can change the threshold by changing
the timeout time of the LeaveAll timer.
LeaveAll
This lower threshold is greater than the
timeout time of the Leave timer. You can
change threshold by changing the timeout
time of the Leave timer.
32,765 centiseconds
The following are recommended GVRP timer settings:
z GARP hold timer: 100 centiseconds (1 second)
z GARP Join timer: 600 centiseconds (6 seconds)
z GARP Leave timer: 3000 centiseconds (30 seconds)
z GARP LeaveAll timer: 120000 centiseconds (2 minutes)
Configuring GVRP Port Registration Mode
Follow these steps to configure GVRP port registration mode:
To do ... Use the command ... Remarks
Enter system view system-view —
Enter Ethernet port view
interface interface-type
interface-number
—
Configure GVRP port registration
mode gvrp registration { fixed |
forbidden | normal }
Optional
By default, GVRP port registration
mode is normal.
Displaying and Maintaining GVRP
To do … Use the command … Remarks
Display GARP statistics
display garp statistics [ interface
interface-list ]
Available in any view