H3C Technologies H3C S3100 Series Switches - Manual (Page 852)

3-2
customer network to the service provider network. The customer network contains Network A and
Network B. You can make the BPDU packets of the customer network to be transmitted in the service
provider network transparently by enabling the BPDU tunnel feature on the edge devices at both ends
of the service provider network.
Figure 3-1 BPDU Tunnel network hierarchy
z When a BPDU packet coming from a customer network reaches an edge device in the service
provider network, the edge device changes the destination MAC address carried in the packet from
a protocol-specific MAC address to a private multicast MAC address, which can be defined using a
command. A packet with this multicast address as its destination address is called a tunnel packet.
In the service provider network, the tunnel packet can be forwarded as a normal data packet.
z Before the device in the service provider network forwards the packet to the destination customer
network, the edge device will identify the tunnel packet, determine the packet type based on the
type field in the packet, restore its destination MAC address to the original protocol-specific MAC
address and then forward the packet to the access device on the user side. This ensures the
packet to be forwarded is consistent with the packet before entering the tunnel. So, a tunnel here
acts as a local link for user devices. It enables Layer 2 protocols to run on a virtual local network.
Figure 3-2 and Figure 3-3 show the structure of a BPDU packet before and after it enter a BPDU tunnel.
Figure 3-2 The structure of a BPDU packet before it enters a BPDU tunnel