H3C Technologies H3C S3100 Series Switches - Manual (Page 875)

1-7
To do… Use the command… Remarks
Create an HWPing test
group and enter its view hwping administrator-name
operation-tag Required
By default, no test group is configured.
Configure the test type test-type dhcp
Required
By default, the test type is ICMP.
Configure the source
interface source-interface interface-type
interface-number
Required
You can only configure a VLAN interface as
the source interface.
By default, no source interface is configured.
Configure the number of
probes per test
count times
Optional
By default, each test makes one probe.
Configure a test
description
description string
Optional
By default, no description information is
configured.
Configure the maximum
number of history records
that can be saved
history-records number
Optional
By default, the maximum number is 50.
Enable history record history-record enable
Optional
By default, history record is not enabled.
Configure the retaining
time of history record
history keep-time keep-time
Optional
By default, the retaining time of history record
is 120 minutes.
Configure statistics
interval and the maximum
number of retained
statistics information
statistics { interval interval |
max-group number }
Optional
By default, statistics interval is 120 minutes
and up to two pieces of statistics information
can be retained.
Configure the retaining
time of statistics
information
statistics keep-time keep-time
Optional
By default, the retaining time of statistics
information is 120 minutes.
Configure test start time
and lifetime
test-time begin { hh:mm :ss
[ yyyy/mm/dd ] | now } lifetime
lifetime Optional
By default, no test start time and lifetime is
configured.
Enable routing table
bypass
sendpacket passroute
Optional
By default, routing table bypass is disabled.
Set the maximum number
of concurrent tests hwping-agent max-requests
number Optional
By default, five concurrent tests are allowed.
Configure the probe
timeout time
timeout time
Optional
By default, a probe times out in three
seconds.
Start the test test-enable Required
Display test results
display hwping results
[ admin-name operation-tag ] Required
You can execute the command in any view.
3) Configuring FTP test on HWPing client
Follow these steps to configure FTP test on HWPing client:
To do… Use the command… Remarks
Enter system view system-view —