H3C Technologies H3C S3100 Series Switches - Manual (Page 829)

4-2
Scheduling a Reboot on the Switch
After you schedule a reboot on the switch, the switch will reboot at the specified time.
Table 4-3 Schedule a reboot on the switch
Operation Command Description
Schedule a reboot on the switch, and set the
reboot date and time schedule reboot at hh:mm [ mm/dd/yyyy
| yyyy/mm/dd ]
Optional
Schedule a reboot on the switch, and set the
delay time for reboot
schedule reboot delay { hh:mm | mm } Optional
Enter system view system-view —
Schedule a reboot on the switch, and set the
reboot period schedule reboot regularity at hh:mm
period
Optional
The switch timer can be set to precision of one minute, that is, the switch will reboot within one minute
after the specified reboot date and time.
Configuring Real-time Monitoring of the Running Status of the System
This function enables you to dynamically record the system running status, such as CPU, thus
facilitating analysis and solution of the problems of the device.
Table 4-4 Configure real-time monitoring of the running status of the system
Operation Command Description
Enter system view system-view —
Enable real-time monitoring of the
running status of the system
system-monitor enable
Optional
Enabled by default.
Enabling of this function consumes some amounts of CPU resources. Therefore, if your network has a
high CPU usage requirement, you can disable this function to release your CPU resources.
Specifying the APP to be Used at Reboot
APP is the host software of the switch. If multiple APPs exist in the Flash memory, you can use the
command here to specify the one that will be used when the switch reboots.