H3C Technologies H3C S3100 Series Switches - Manual (Page 818)

1-12
This will update BootRom file on unit 1. Continue? [Y/N] y
Upgrading BOOTROM, please wait...
Upgrade BOOTROM succeeded!
Step 3: Restart the switch.
reboot
Before restarting the switch, make sure you have saved all other configurations that you want, so as to
avoid losing configuration information.
2) Loading host software
Loading the host software is the same as loading the Boot ROM program, except that the file to be
downloaded is the host software file, and that you need to use the boot boot-loader command to select
the host software used for next startup of the switch.
After the above operations, the Boot ROM and host software loading is completed.
Pay attention to the following:
z The loading of Boot ROM and host software takes effect only after you restart the switch with the
reboot command.
z If the space of the Flash memory is not enough, you can delete the unused files in the Flash
memory before software downloading. For information about deleting files, refer to the “File System
Management” part of this manual.
z Ensure the power supply during software loading.
Loading Procedure Using FTP Server
As shown in Figure 1-9 , the switch is used as the FTP server. You can telnet to the switch, and then
execute the FTP commands to upload the Boot ROM switch.btm to the switch.
1) Loading the Boot ROM
Figure 1-9 Remote loading using FTP server
Step 1: As shown in Figure 1-9 , connect the switch through an Ethernet port to the PC (whose IP
address is 10.1.1.1)
Step 2: Configure the IP address of VLAN-interface 1 on the switch to 192.168.0.28, and subnet mask
to 255.255.255.0.