H3C Technologies H3C S3100 Series Switches - Manual (Page 793)

1-7
Task Remarks
Setting to Output System Information to the SNMP NMS Optional
Configuring Synchronous Information Output
Synchronous information output refers to the feature that if the system information such as log, trap, or
debugging information is output when the user is inputting commands, the command line prompt (in
command editing mode a prompt, or a [Y/N] string in interaction mode) and the input information are
echoed after the output.
This feature is used in the case that your input is interrupted by a large amount of system output. With
this feature enabled, the system echoes your previous input and you can continue your operations from
where you were stopped.
Table 1-5 Configure synchronous information output
Operation Command Description
Enter system view system-view —
Enable synchronous information
output
info-center synchronous
Required
Disabled by default
z If the system information is output before you input any information following the current command
line prompt, the system does not echo any command line prompt after the system information
output.
z In the interaction mode, you are prompted for some information input. If the input is interrupted by
system output, no system prompt (except the Y/N string) will be echoed after the output, but your
input will be displayed in a new line.
Configuring to Display the Time Stamp with the UTC Time Zone
To add UTC time zone to the time stamp in the information center output information, you must:
z Set the local time zone
z Set the time stamp format in the output direction of the information center to date
z Configure to add the UTC time zone to the output information
Table 1-6 Configure to display time stamp with the UTC time zone
Operation Command Description
Set the time zone for the system
clock timezone zone-name { add |
minus } time
Required
By default, UTC time zone is
set for the system.
Enter system view system-view —