H3C Technologies H3C S3100 Series Switches - Manual (Page 878)

1-10
To do… Use the command… Remarks
Configure the source IP address source-ip ip-address
Optional
By default, no source IP address is
configured.
Configure the source port source-port port-number
Optional
By default, no source port is
configured.
Configure the number of probes
per test
count times
Optional
By default, each test makes one
probe.
Configure a test description description string
Optional
By default, no description information
is configured.
Configure the maximum number of
history records that can be saved
history-records number
Optional
By default, the maximum number is
50.
Enable history record history-record enable
Optional
By default, history record is not
enabled.
Configure the retaining time of
history record
history keep-time keep-time
Optional
By default, the retaining time of
history record is 120 minutes.
Configure statistics interval and the
maximum number of retained
statistics information
statistics { interval interval |
max-group number }
Optional
By default, statistics interval is 120
minutes and up to two pieces of
statistics information can be retained.
Configure the retaining time of
statistics information
statistics keep-time keep-time
Optional
By default, the retaining time of
statistics information is 120 minutes.
Configure test start time and
lifetime
test-time begin { hh:mm :ss
[ yyyy/mm/dd ] | now } lifetime
lifetime Optional
By default, no test start time and
lifetime is configured.
Enable routing table bypass sendpacket passroute
Optional
By default, routing table bypass is
disabled.
Configure the TTL ttl number
Optional
By default, TTL is 20.
The sendpacket passroute command
voids the ttl command.
Configure the automatic test
interval
frequency interval
Optional
By default, the automatic test interval
is zero seconds, indicating no
automatic test will be made.
Configure the probe timeout time timeout time
Optional
By default, a probe times out in three
seconds.
Configure the type of service tos value
Optional
By default, the service type is zero.