H3C Technologies H3C S3100 Series Switches - Manual (Page 613)

2-2
A user-based QoS profile application fails if the traffic classification rule defined in the QoS profile
contains source address information (including source MAC address information, source IP address
information, and VLAN information).
Manual application mode
You can use the apply command to manually apply a QoS profile to a port.
QoS Profile Configuration
Table 2-1 QoS profile configuration tasks
Operation Description Related section
Configure a QoS Profile Required Section Configuring a QoS Profile
Configure to apply a QoS Profile
dynamically
Optional Section Applying a QoS Profile
Apply a QoS Profile manually Optional Section Applying a QoS Profile
Configuring a QoS Profile
Configuration prerequisites
z The ACL rules used for traffic classification are defined. Refer to the ACL module of this manual for
information about defining ACL rules.
z The type and number of actions in the QoS profile are specified.
Configuration procedure
Table 2-2 Configure a QoS profile
Operation Command Description
Enter system view system-view —
Create a QoS profile and
enter QoS profile view
qos-profile profile-name
Required
If the specified QoS profile
already exists, you enter the
QoS profile view directly.
Configure traffic policing
traffic-limit inbound acl-rule
target-rate [ burst-bucket
burst-bucket-size ] [ conform
con-action ] [ exceed
exceed-action ] [ meter-statistic ]
Optional
Configure packet filtering packet-filter inbound acl-rule
Optional
Refer to the ACL module of this
manual for information about
packet filtering.
Configure priority marking
traffic-priority inbound acl-rule
{ dscp dscp-value | cos cos-value |
Optional