Configuring traffic shaping, Configuration prerequisites, Configuration procedure – H3C Technologies H3C S3100 Series Switches User Manual
Page 600: Configuration examples, Configuring port rate limiting
1-21
[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] traffic-limit vlan 2 inbound ip-group 2000 128 exceed remark-dscp 56
Configuring Traffic Shaping
Only H3C S3100-EI series switches support this configuration.
Refer to section
Traffic Policing and Traffic Shaping
for information about traffic shaping.
Configuration prerequisites
z
The maximum traffic rate and the burst size are determined.
z
The port where traffic shaping is to be configured is determined.
Configuration procedure
Table 1-22 Configure traffic shaping
Operation
Command
Description
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Configure traffic shaping
traffic-shape queue
queue-id max-rate burst-size
Required
Traffic shaping is not enabled by
default.
Configuration examples
# Perform traffic shaping for all the traffic to be transmitted through Ethernet 1/0/1, with the maximum
traffic rate being 640 kbps and the burst size being 16 KB.
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] traffic-shape 640 16
Configuring Port Rate Limiting
Refer to section
for information about port rate limiting. Note that, the target-rate
argument is committed information rate (CIR).
Configuration prerequisites
z
The port on which port rate limiting configuration is to be performed is determined.
z
The target rate and the direction of rate limiting (inbound or outbound) are determined.