H3C Technologies H3C S3100 Series Switches - Manual (Page 797)

1-11
Make sure that the debugging/log/trap information terminal display function is enabled (use the
terminal monitor command) before you enable the corresponding terminal display function by using
the terminal debugging, terminal logging, or terminal trapping command.
Setting to Output System Information to a Log Host
Table 1-12 Set to output system information to a log host
Operation Command Description
Enter system view system-view —
Enable the information center info-center enable
Optional
Enabled by default.
Enable system information
output to a log host
info-center loghost host-ip-addr
[ channel { channel-number |
channel-name } | facility
local-number ]*
Required
By default, the switch does not output
information to the log host.
After you configure the switch to
output information to the log host, the
switch uses information channel 2 by
default.
Configure the source interface
through which log information
is sent to the log host
info-center loghost source
interface-type interface-number
Optional
By default, no source interface is
configured, and the system
automatically selects an interface as
the source interface.
Configure the output rules of
system information
info-center source { modu-name |
default } channel
{ channel-number | channel-name }
[ { log | trap | debug } { level
severity | state state } ]*
Optional
Refer to Table 1-8 for the default
output rules of system information.
Set the format of the time
stamp to be sent to the log host info-center timestamp loghost
{ date | no-year-date | none }
Optional
By default, the time stamp format of
the information output to the log host
is date.
Be sure to set the correct IP address when using the info-center loghost command. A loopback IP
address will cause an error message prompting that this address is invalid.