H3C Technologies H3C S3100 Series Switches - Manual (Page 214)

1-11
Configuring MAC Address Replication
The contents of this section are only applicable to the S3100-EI series among S3100 series switches.
Follow these steps to configure the MAC address replication feature:
To do... Use the command... Remarks
Enter system view system-view —
Enter Ethernet port view
interface interface-type
interface-number
—
Configure MAC address
replication
mac-address-mapping index
source-vlan source-vlan-id-list
destination-vlan dest-vlan-id Required
By default, the MAC address
replication feature is disabled.
z On a port, the MAC address replication feature can be configured only once for a destination VLAN.
If the configuration needs to be modified, you need to remove the existing configuration first.
z With the MAC address replication feature disabled, all the MAC address entries that the destination
VLAN learns from the other VLANs through this function are removed.
z MAC address entries obtained through the MAC address replication feature cannot be removed
manually. To remove a MAC address entry of this kind, you need to disable the MAC address
replication feature first.
Displaying MAC Address Table Information
To do… Use the command… Remarks
Display information about the MAC
address table
display mac-address [ display-option ]
Display the aging time of the
dynamic MAC address entries in
the MAC address table
display mac-address aging-time
Display the configured start port
MAC address
display port-mac
Available in any view