Network diagram, Configuration procedure, Shown in – H3C Technologies H3C S3100 Series Switches User Manual

Page 738: Figure 1-13

1-25

Network diagram

Figure 1-13 Switch acts as server for password and RADIUS authentication

Configuration procedure

1) Configure the RADIUS server

This document takes CAMS Version 2.10 as an example to show the basic RADIUS server

configurations required.

# Add an access device.

Log into the CAMS management platform and select System Management > System Configuration

from the navigation tree. In the System Configuration window, click Modify of the Access Device

item, and then click Add to enter the Add Access Device window and perform the following

configurations:

Specify the IP address of the switch as 192.168.1.70.

Set both the shared keys for authentication and accounting packets to expert.

Select LAN Access Service as the service type.

Specify the ports for authentication and accounting as 1812 and 1813 respectively.

Select Extensible Protocol as the protocol type.

Select Standard as the RADIUS packet type.